Section uploaded on website is blank

This forum is designated to discuss WISE-FTP.
Post Reply
interact
Newbie
Newbie
Posts: 2
Joined: February 4th, 2008, 4:42 pm

Section uploaded on website is blank

Post by interact » February 4th, 2008, 4:46 pm

I seemingly successfully upload an amended document from my local to the remote system, but when I look at the website the entire text section is missing. I keep repeating and refreshing but it is still missing.

Any ideas on what might be the problem?

Support (AceBIT)

Re: Section uploaded on website is blank

Post by Support (AceBIT) » February 5th, 2008, 10:46 am

Hello,

please make sure that the Binary mode transfer is checked. This problem might happen when a binary document is uploaded in the ASCII mode.

Best regards

interact
Newbie
Newbie
Posts: 2
Joined: February 4th, 2008, 4:42 pm

Re: Section uploaded on website is blank

Post by interact » February 5th, 2008, 12:00 pm

Thanks very much - but I have now tried binary mode several times and it's still not appearing on the home page. I just had a look at the document in the remote system and it wouldn't open - it listed a 'Microsoft JScript compliation error', Expected ';'

Any ideas?

Support (AceBIT)

Re: Section uploaded on website is blank

Post by Support (AceBIT) » February 5th, 2008, 12:17 pm

Hello,

could you please tell us what the average speed of upload is and which kind of connection to the internet you are using?

Please also try the following: in the Site Manager select the server and on the tab Advanced uncheck the option "use global speed limits" and set the values for the upload and download to 20 KB/sec and 100 KB/sec.

Best regards

Post Reply