Page 1 of 1

"Schedule" section of properties shows "Access violation"

Posted: May 11th, 2012, 6:22 pm
by SteveDC
OK, this is an interesting one...
I am trying to enable scheduling of a backup so I open the backup project, right click on it and select "properties". I then get the AceBackup properties dialog for the project. next I select the advanced tab and the 'schedule' section of the dialog displays an access violation message. Note, this is not a new dialog popping up with an access violation (as normally happens when a program causes an access violation), but the text appears in the existing dialog window as a text string.

I have attached a screen capture to show what I mean. (Seriously !!! .BMP is not an allowed attachment !!! OK, rename it to BMP. What... TXT & LOG are not allowed either!!!??/ What the hell extensions ARE allowed then???)

The 'settings' button is also greyed out so I can't schedule a backup.

Thoughts?

Re: "Schedule" section of properties shows "Access violation

Posted: May 21st, 2012, 10:03 pm
by SteveDC
OK, so I assume nobody from Acebit monitors these forums :(

Re: "Schedule" section of properties shows "Access violation

Posted: June 26th, 2012, 2:14 pm
by eren
Hello Steve,
AceBIT provides no support for freeware.

"Support for AceBackup
AceBackup is given to the Internet community for free. AceBIT does therefore not offer a hotline nor technical support by email.
In case you have any questions or problems, please refer to the forum and ask the community or read the documentation and FAQs."

Have you tried to upload it as a .jpg?